Street Lighting from Cannon

Products

Brackets

Tubular Bracket Double Arm - Type 14

The Type 14 Tubular Bracket Single Arm is manufactured to fit inside the top of the shaft. These are held in place by grub screws located in the top of the shaft, clamping onto the bracket spigot. This gives a flush finish between the bracket and column shaft.

The bracket can be supplied with a 5mm gusset for additional strength, according to the lamp weight.

Common column diameters (A) are 76, 89, 101, 114, 127 and 139mm.

Common arm diameters are (B) 34, 42 and 48mm.

Additional measurements required for the Spigot / Pot diameter (B) and the Projection diameter.

For your custom-made brackets please refer to the chart below and complete the appropriate sizes.

Part No.	Column Diameter (A)	Arm Diameter (B)	Height to Light Source (C)	Projection (D)	Uplift Angle	Finish
TA8001	76 mm	34 mm	300 mm	300 mm	5⁰	Galvanised
TA8002	76 mm	34 mm	300 mm	500 mm	5⁰	Galvanised
TA8003	76 mm	34 mm	300 mm	750 mm	5⁰	Galvanised
TA8004	76 mm	34 mm	300 mm	1000 mm	5⁰	Galvanised
TA8005	76 mm	34 mm	300 mm	1250 mm	5⁰	Galvanised
TA8006	76 mm	34 mm	300 mm	1500 mm	5⁰	Galvanised
TA8007	89 mm	34 mm	300 mm	750 mm	5⁰	Galvanised
TA8008	114 mm	42 mm	300 mm	1250 mm	5⁰	Galvanised
TA8009	139 mm	48 mm	300 mm	1500 mm	5⁰	Galvanised
CUSTOMER SPECIFIC SIZE: