Street Lighting from Cannon

Products

Brackets

Tubular Bracket Single Arm - Type 11

The Type 11 Tubular Bracket Single Arm is manufactured to fit inside the top of the shaft. These are held in place by grub screws located in the top of the shaft, clamping onto the bracket spigot. This gives a flush finish between the bracket and column shaft.

Additional measurements required for the Spigot / Pot diameter (B) and the Projection diameter.

Common column diameters (A) are 76, 89, 101, 114, 127 and 139mm.

Common arm diameters are (B) 34, 42 and 48mm.

Brackets are manufactured from mild steel and hot dipped galvanised to BS EN ISO1461.

For your custom-made brackets please refer to the chart below and complete the appropriate sizes.

Part No.	Column Diameter (A)	Arm Diameter (B)	Height to Light Source (C)	Projection (D)	Uplift Angle	Finish
TA3001	76 mm	34 mm	370 mm	300 mm	5⁰	Galvanised
TA3002	76 mm	34 mm	370 mm	500 mm	5⁰	Galvanised
TA3003	76 mm	34 mm	370 mm	750 mm	5⁰	Galvanised
TA3004	76 mm	34 mm	370 mm	1000 mm	5⁰	Galvanised
TA3005	76 mm	34 mm	370 mm	1250 mm	5⁰	Galvanised
TA3006	76 mm	34 mm	370 mm	1500 mm	5⁰	Galvanised
TA3007	89 mm	34 mm	370 mm	750 mm	5⁰	Galvanised
TA3008	114 mm	42 mm	370 mm	1250 mm	5⁰	Galvanised
TA3009	139 mm	48 mm	370 mm	1500 mm	5⁰	Galvanised
CUSTOMER SPECIFIC SIZE: